Welcome

You can follow the instructions here, or skip to the scanning stage if you've completed the paper instructions.

By continuing, you agree to the terms & conditions.
Get Ready

Before proceeding, ensure you've done the following:

•
Gently wash face with only water (no cleanser or soap), then dry.
Get Ready image 1A
•
Designate Sample Tubes as either "Control" or "Test" as you prefer. Note cap color or mark them to avoid mix-up.
Get Ready image 2A
Step 1: Insert Control

Insert a clean, unused Collection Disc into a Sample Tube (Control).

Step 1 illustration
(Ensure adhesive side faces inward to center)
Step 2: Sample Skin

Adhere a Collection Disc to the cheekbone area under your eye. Press firmly 8 times.

Step 2 illustration
Step 3: Insert Test

Place the sampled Collection Disc into a second Sample Tube (Test).

Step 3 illustration
(Ensure adhesive side faces inward to center)
Step 4: Add Buffer

Add 10 drops from the Buffer Tube to each Sample Tube using the Dropper.

Step 4 illustration
(Avoid touching the Dropper tip to the sample liquid.)
Step 5: Mix Tubes

Cap the tubes and shake them 10 times. Let rest for 5 minutes. Liquid may change color.

Step 5 illustration
05:00
You can use this built-in silent timer if desired.
Step 6: Scan

You'll now use the included Test Reader Card and your camera. Before scanning, make sure to:

  • Wait for the full 5 minute color reaction, then complete scan within 3 minutes
  • You're on minimum iOS 17.4 or Android 7 with a modern browser
  • Place the Test Reader Card on a dark, contrasting surface with good neutral lighting
  • Place the tubes in the correct positions without direct glare
Step 6 illustration